American Dynamics RHODUL-03E Specifications download pdf (Page 2)

Warnings and Cautions

Please review the following warnings and cautions

before you begin installation or service.

Warnings

WARNING! Always use proper lift and

safety equipment for the location and

type of installation. Use the safety

features of the lift equipment.

When connecting wires, ensure electrical

power is not connected to the camera

dome. The dome will move when power

is applied. Also, ensure electrical power

is not connected to nearby fixtures that

you might touch during installation.

WARNING! The camera dome runs on

24Vac. DO NOT connect line voltage to

the dome.

North America power requirements: In

North America, this device is intended to

be supplied from a Class 2 power

supply. For outdoor installations, use

Class 3 wiring techniques, liquid-tight

conduit, or liquid-tight pipe.

This installation should be made by a

qualified service person and should

conform to all local codes.

WARNING! DO NOT install this housing

where combustible or explosive products

are stored or used.

WARNING! EU power requirements:

This product runs on 24Vac. In the EU, it

is intended to be powered from a Limited

Power Source. A limited power source is

a certified source of SELV, and if inher-

ently limited, with 8 amps maximum

output current, and a maximum of 100VA

available; or if not inherently limited,

fused with a maximum value of 3.3

Amps, meeting section 2.11 of IEC950,

and a maximum of 250VA available. The

power supply can be obtained through

Sensormatic or through another source

where the provider can furnish the

verification. This is required to assure

electrical safety in the product.

Stromanforderungen in der EU: Dieses

Produkt wird mit 24 V Wechselstrom

betrieben. In der EU ist es für den

Betrieb durch eine begrenzte

Stromquelle vorgesehen. Eine begrenzte

Stromquelle ist eine zertifizierte SELV-

Quelle (Schutzkleinspannung), bei

inhärenter Begrenzung mit einem

maximalen Ausgangsstrom von 8 A und

100 VA maximaler Verfügbarkeit, bei

nicht inhärenter Begrenzung mit einer

maximalen Sicherung von 3,3 A gemäß

Abschnitt 2.11 der IEC950 und 250 VA

maximaler Verfügbarkeit. Das Netzteil

kann über Sensormatic oder eine andere

Quelle bezogen werden, wobei der

Anbieter den Nachweis der Konformität

bereitstellen sollte. Dies ist zur

Gewährleistung der elektrischen

Sicherheit des Produktes erforderlich.

Cautions

• The bubble assembly comes in a separate box.

To protect the bubble assembly, leave it in its

box until you are ready to install it.

• Do not run data/power cables adjacent to or in

the same conduit as line voltage mains power.

• Network cable/device restrictions:

- SensorNet requires 22AWG unshielded

cable. Do not exceed 32 devices per cable

run.

- RS422 requires 22AWG shielded cable. Do

not exceed 10 devices per cable run.

- Manchester requires 18AWG shielded cable.

Do not exceed 3 devices per cable run.

• Outdoor housing contains an environmental PC

board. Touch the metal housing to discharge

static electricity before touching the board.

• Use a 2.5mm (0.1in) slotted screwdriver to

tighten PC board connectors. Using a blade too

wide can damage connectors. Do not over

tighten connectors.

• When connecting the camera dome to the

outdoor housing:

- Remove both slot covers to keep the camera

from overheating

- Keep cables within the housing away from

the heater assembly

- Check heater fan operation. Both fans must

be on to prevent overheating.

- If required, set communication line

termination inside the housing (see

“Unterminating the Housing”).

RHODUL-03VR/-04VR SPEEDDOME ULTRA VANDAL-RESISTANT OUTDOOR HOUSING 8200-0184-11, REV. A

INSTALLATION AND SERVICE GUIDE

2 of 14

1 2 3 4 5 6 7 ... 13 14

Comments to this Manuals

No comments

American Dynamics RHODUL-03E Specifications Page 2

Comments to this Manuals