American Dynamics illustra 400 User Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
VideoEdge NVR 4.1 Release Notes
26
8200-2735-07 D0
Unable to add an AD IP SpeedDome if it is beyond the IP broadcast range of the NVR.
If Auto Flip is disabled, then the amount of distance of tilt down will be larger when it is close
to -90 degrees than other positions.
If Auto Flip is enabled, then the tilt down operation in NVR will lock the motor which make
auto flip fail because the tilt down in NVR is not continues (e.g. moveBy) and the moving
amount of distance is very tiny.
Camera digital PTZ is not supported in this release. So it is not implemented normalization for
digital PTZ part.
The maximum performance of H.264 is D1 @ 20 fps @ quality 70
The zoom speed is fixed.
Audio will not work unless it is enabled through the camera web interface
Known Issues
The default values for some properties defined on NVR are different from camera‟s default.
The dry contact state always return unknown.
The definition of preset and pattern in NVR might be changed by user via web-client.
The NVR will not recognize any presets or patterns already on the dome when it is added to
the NVR.
The NVR will not recognize any presets or patterns added to the dome via its web interface
and in fact the NVR may overwrite them.
Preset and pattern definitions made on the NVR will be mirrored to the device, but not the
other way around.
Preset and pattern definitions should be retained in case of network loss or disconnection /
reconnection.
Preset and pattern definitions will not be deleted when the dome is deleted from the NVR.
Clients should show only the presets and patterns that have been defined using the NVR (not
all 96 slots, defined or not). Presets and patterns defined through the device web
configuration will not be shown.
NOTE: Please refer to AD IP SpeedDome Release Notes for additional information.
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Comments to this Manuals

No comments