American Dynamics Illustra Flex Series User's Guide download pdf (Page 10)

Illustra Flex 1MP & 3MP Bullet

2.2.2 Mounting the camera

1. Affix the mounting template to the desired location, knock in 6 plastic anchors after hole drilling and then

lock in 6 self-tapping screws to fasten the camera.

FIGURE 2-1: MOUNTING THE CAMERA

2. Mount the unit onto the ceiling/wall and fasten it securely.

IGURE 2-2: MOUNTING THE CAMERA

Warning

Depending on the material of mounting surface, different screws and anchors than those

supplied may be required. To prevent the unit from falling off, ensure that it is mounted to a

firm place (ceiling slab or channel) using a safety wire strong enough to withstand the total

weight of the unit. (Pay also attention to the finishing at the end of the wire.)

Caution

Safety wire must be connected with one end the wall/ceiling and the other to the safety-cord

screw of the unit. By cabling so, it is possible to prevent the unit from accidental falling in a

sudden at any time.

Safety wire (fall prevention wire, not supplied)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 48 49

No comments

American Dynamics Illustra Flex Series User's Guide Page 10