American Dynamics RAS918LSP Specifications download pdf (Page 25)

SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME 8200-0184-14, REV. A

INSTALLATION AND SERVICE GUIDE

25 of 37

Detailed Troubleshooting

Use this procedure to determine if the problem is a

simple cable connection or a major component.

To perform this procedure, you must open the

housing and eyeball assembly. Refer to

"Disassembling the Dome" on page

26.

CAUTION:

• DO NOT use this procedure if the dome

functions but does not pan or tilt (see step 2 on

page

22).

• If routine troubleshooting did not solve the

problem, the manufacturer strongly

recommends you contact your sales

representative for repair instructions. If you must

perform detailed troubleshooting, use extreme

care when disassembling parts!

• When shipping a base with I/O board, place the

dust cover over the spring fingers to protect

them.

• Delicate connector screws on I/O board. DO

NOT over tighten them! Use a 2.5mm (0.1in)

slotted screwdriver. Wider blade widths can

damage connectors.

• Dome contains electrostatic-sensitive PC

boards. Use a ground strap when handling

boards.

Procedure

1. Match symptom to one of the following criteria:

− Dome functions but does not pan

− Dome functions but does not tilt

− Dome does not "home" or respond to

commands even when attached to another

dome's base and its address switches are

set correctly (dead dome).

2. Choose a, b, or c to determine if problem is a

cable connection or major component.

a. Dome functions but does not pan.

On CPU board, is pan motor ribbon cable

attached to connector P4 and is metal side of

its fingers towards contacts of connector?

YES Replace CPU board. If this doesn't

work, replace pan motor.

NO Connect cable(s).

b. Dome functions but does not tilt.

On camera/lens board, is tilt motor cable

attached to connector J3? Is slip ring cable

attached to connector J2?

YES Replace camera/lens board. If this

doesn't work, replace tilt motor.

NO Connect cable(s).

c. Dome does not "home" or respond to

commands (dead dome).

On CPU board, is power supply cable

attached to connector P3? Is slip ring cable

attached to connector P2?

YES Replace CPU board. If this doesn't

work, replace power supply board.

NO Connect cable(s).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 36 37

Comments to this Manuals

No comments

American Dynamics RAS918LSP Specifications Page 25

Comments to this Manuals

Related products and manuals for Security cameras American Dynamics RAS918LSP