American Dynamics illustra 400 Specifications download pdf (Page 30)

30 Installation and Operation Guide

3.3 Updating System Software

If the system software of the IP Camera needs to be upgraded, please take the following steps to

safely process it.

Important: Before carrying out the following procedures, please ensure the SD card is

working and the file of the system firmware is intact.

1. Create a directory named UPGRADE (upper-case or lower-case letters are no difference) in

the SD card if it does not exist.

2. Copy the file UPDATE.BIN to the UPGRADE directory.

3. If the IP Camera is running, please power it off first.

4. Insert the SD CARD into the IP Camera.

5. Remove the Ethernet cable from the RJ-45 port and then power on the IP Camera.

6. In 5 to 10 seconds, a message reading "UPDATE PROCESSING" will show up on the screen

on a blue background; if not, please check out steps 1 to 6 carefully or else inform your

technical support while ignoring the following steps.

7. DO NOT power off the IP Camera while this update process is running until the message

"UPDATE OK RESET PLEASE" appears on the screen; it might take 15 to 30 seconds to

appear.

8. If the message "UPDATE NG RESET PLEASE" appears rather than "UPDATE OK RESET

PLEASE", please write down the error messages shown on the screen and inform your

technical support, while ignoring the following steps.

9. Power off the IP Camera when this update process is finished, then remove the SD card from

the IP Camera.

10. Reconnect the Ethernet cable to the RJ-45 port if necessary.

11. Power ON the IP Camera and it will work normally if the entire update procedure goes

correctly.

12. Verify the version of the system software.

WARNING:

 You must perform Steps 1 to 2 on a PC.

 Ensure you are using the correct UPDATE.BIN file in Step 2, otherwise the IP Camera

will not work properly.

 If the power of the IP Camera is suddenly lost in step 7, please remove the SD card

first and turn on the IP Camera next to test its operation. If the IP Camera remains

working normally, please go back to step 3; otherwise, please inform your technical

support.

 In step 9, if the SD card is not removed and the IP Camera does not get online as well,

the updating process must be repeated again after rebooting the IP Camera.

 Make sure that the SD card is inserted in a correct position in step 4, or the IP Camera

will suffer permanent physical damage.

 If the message "CSUM ERROR" appears in step 7, it implies a problem in the

UPDATE.BIN file.

 Do not interrupt the process when the unit is updating or it will crash.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 105 106

No comments

American Dynamics illustra 400 Specifications Page 30