American Dynamics RAS917LS-1 Specifications download pdf (Page 20)

SPEEDDOME ULTRA VII CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0184-01, REV. A1)

20 of 41

Using the Install/Removal

Tool

CAUTION: Do not use this tool to connect the

dome to the standard base.

Used only when the dome is connected to a base

having an I/O board, the RHIRT install/removal tool

eliminates the need for a ladder during routine

service. The tool can be used to:

· Detach skirt or bubble from housing, if used.

The skirt or bubble remains attached to the

housing during service.

· Connect/Disconnect dome from base with I/O

board.

· Reattach skirt or bubble.

Telescopic Pole Required to Use Tool

The tool attaches to a telescopic pole similar to the type

used to clean swimming pools. The pole should be 5

feet, 5 inches to 15 feet, 5 inches long and have a 1.170

-inch inside diameter to accept the 1.125 inch diameter

stem of the tool. If this pole cannot be obtained locally,

contact the following manufacturer:

Recreational Water Products

627 E. College Ave.

Decatur, GA 33030

Ask for product code 08140

UPC: 0-14746-58140-2

Procedure

Referring to Figure 19, maneuver the stem of the

tool into the top of the pole until it snaps in place.

TO ATTACH SKIRT OR BUBBLE:

Use tool to push up on bubble and to secure it in

place. Magnets secure the bubble. Lower pole.

TO DETACH SKIRT OR BUBBLE:

Lifting pole up at an angle, use one of the hooks on

tool to catch one of the notches at side of dome

and pull down. T-lanyard will prevent skirt or

bubble from falling.

TO CONNECT DOME:

1. Insert dome "eyeball down" into tool's

receptacle. Fins on dome mate with slots in tool.

Use fins to properly align dimple at top of dome

with label on tool.

2. Align label on tool with logo on I/O board in

base. Push dome up into place.

3. Turn dome clockwise until it clicks.

4. If power is applied, dome should begin its

"homing" routine.

5. Lower pole.

TO DISCONNECT DOME:

1. Raise pole and insert dome "eyeball down"

into tool's receptacle.

2. Fins on dome mate with slots in tool.

3. Turn dome counterclockwise until it unlocks.

4. Lower pole "vertically" to prevent camera dome

from falling out.

CAUTION: Turning pole horizontally as it is

lowered can cause camera dome to fall out of

tool and possibly break on floor.

5. Remove dome for service.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 40 41

Comments to this Manuals

No comments

American Dynamics RAS917LS-1 Specifications Page 20

Comments to this Manuals

Related products and manuals for Security cameras American Dynamics RAS917LS-1