American Dynamics MegaPower 3200 Installation Guide download pdf (Page 12)

MEGAPOWER CPU 8200-0421-03, REV. G

ADMINISTRATOR’S GUIDE

10 of 82

4. Switch on the CPU. The LCD screen displays the

AD Welcome Screen (

Figure 10), followed by the

CPU Status screen, two examples of which are

shown in

Figure 11.

Figure 10. AD welcome screen

Figure 11. CPU status screen

or

Using an IP Address Assigned by the

Network DHCP Server

To set up the MegaPower CPU to obtain an IP

address from a DHCP server, do the following:

1. Connect a keyboard to an RS-232 port on the

MegaPower CPU. Ensure the baud rates match

for the keyboard and CPU port in use.

2. Use the following instructions to provide the key

sequences for each supported keyboard:

AD2088:

a. Place the keyboard in Menu Mode by turning

the keyswitch to MENU. The Camera field

LED on the keyboard should display P6.

b. Enter one of the following number sequences

for your MegaPower CPU installation:

○ Standalone MPCPU: Enter 100.

○ Dual MPCPU: Enter 100 for the selected

MegaPower CPU, or enter 101 for the

Standby MP CPU.

c. Press the ENTER key, which is located above

the joystick. “ENTER” is stenciled on the front

face of the key; the top of the key may be

labeled either PRESET or SHOT.

The Camera field LED on the keyboard will

only display 7P if the selected CPU is

accessed.

ADCC1100:

a. Place the keyboard in Program Mode by

clicking the tab in the middle of the lower part

of the screen).

Note: To display and enter Program Mode, you

must insert a Smartcard that has administrator

privileges.

b. Press the Matrix Menus softkey.

c. Enter one of the following number sequences

for your MegaPower CPU installation:

○ Standalone MPCPU: Enter 100.

○ Dual MPCPU: Enter 100 for the selected

MegaPower CPU, or enter 101 for the

Standby MP CPU.

d. Press the Enter softkey.

ADCC0200/0300:

Notes: In RS–232 mode, the ADCC0200

keyboard does not have matrix menu access

capabilities as indicated by the Access Denied

message if the following procedure is attempted.

a. Press and hold the Shift (

) button and then

press the Menu (

) button.

b. Enter one of the following number sequences

for your MegaPower CPU installation:

○ Standalone MPCPU: Enter 100.

○ Dual MPCPU: Enter 100 for the selected

MegaPower CPU, or enter 101 for the

Standby MP CPU.

c. Press Enter (

).

Note: Whenever scrolling to a different line

item on the LCD screen, you must press

twice to select the new item.

Note: To exit Program Mode, press and hold the

Shift (

) button, and then press the Clear ( )

button.

ADTTE:

a. Place the keyboard in Program Mode

(indicated by –P being displayed at the far right

of the LCD).

b. Press the Menu key. The LCD screen displays

P6 - M.

c. Enter one of the following number sequences

for your MegaPower CPU installation:

○ Standalone MPCPU: Enter 100

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 85 86

Comments to this Manuals

No comments