American Dynamics MegaPower 3200 Installation Guide download pdf (Page 41)

MEGAPOWER CPU 8200-0421-03, REV. G

ADMINISTRATOR’S GUIDE

39 of 82

Contact Arming

The Contact Arming screen enables you to assign a

group of contacts in an alarm table to a monitor.

Figure 77. Contact Arming screen

To begin assigning a group of contacts to a monitor

from the Alarms – Monitor screen:

1. Click on a monitor.

2. Click the Contact Arming tab. The selected

monitor number appears just below the tab in the

Monitor field.

3. Click Add on the right side of the screen. The Add

Contacts dialog box appears (

Figure 78 on

page

39).

Figure 78. Add Contacts dialog

The Add Contacts dialog provides three options.

1. To select an option, click the button beside the

option, and complete the required information.

Options are:

− Replace with the following sequence – enter

a range of monitors, for example, 1-256.

− Add a single Contact – Click the up or down

arrows to select a contact.

− Add a range of Contacts – Click the up or

down arrows on the “from” and “to” fields to

select a range of contacts.

2. Click OK to save your contact choices or Cancel

to close the dialog box without saving your

choices.

Deleting Contacts

To delete contacts assigned to a monitor as defined

in the Contact Arming tab, do the following:

1. In the upper screen, click on the monitor that

contains the contact(s) to be deleted.

2. Click on the contact(s) in the lower screen to be

deleted, and then press Remove on the right side

of the screen.

Event Timers

The Event Timers tab in the Alarms – Monitor screen

allows you to view and delete event timer information

that is associated with selected monitors.

Note: Event timers displayed in this screen are for

information only, and they cannot be added or edited

here. You must define event timers in the Switching –

Event Timer screen as described on page

35.

Viewing Event Timers

To view event timer information from the Alarms –

Monitor screen:

1. Click on a monitor in the upper screen.

2. Click the Event Timers tab on the Alarms –

Monitor screen.

Figure 79. Event timers screen

Deleting Event Timers

To delete an event timer definition:

1. Click on a monitor in the upper screen.

2. Click the header of the row in the lower screen

that contains the event timer definition to be

deleted.

3. Press the keyboard Delete key of the PC running

EASY CPU. The Delete Rows dialog box

appears.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 85 86

Comments to this Manuals

No comments

American Dynamics MegaPower 3200 Installation Guide Page 41

Comments to this Manuals

Related products and manuals for Processors American Dynamics MegaPower 3200