American Dynamics VideoEdge User Manual download pdf (Page 195)

100

101

Network Settings

179

5 To edit the LAN IP Address, enter the desired IP Address in the field.

6 T

o edit the Subnet Mask, enter the desired Subnet Mask in the field.

7 T

o edit the IP Broadcast Address, enter the desired Broadcast Address in the field.

8 Click

Save.

Note

The displayed MAC Address cannot be edited.

- End -

DHCP Server Settings

The DHCP Server page provides the option to configure the NVR to host a DHCP Server for each

network card plugged into the system. This allows the NVR to allocate IP addresses from the

range specified when other devices request IP allocation.

The page allows you to edit the DHCP Status and the Start and End Range of IP Addresses to be

cluded during automatic searching for IP Devices.

The DHCP Status page allows you to view all a

ctive devices which have been assigned an IP

address by the NVR acting as a DHCP server. The page displays the IP addresses in use by the

device, its MAC address, when it was last active and the device’s hostname.

Caution

You should only set up the NVR as a DHCP Server if you are positive the LAN does not already have a

DHCP Server, and the NVR has been assigned a static IP Address. Otherwise you could have two

different DHCP Servers giving out IP addresses, and this could cause network problems.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 373 374

Comments to this Manuals

No comments

American Dynamics VideoEdge User Manual Page 195

Comments to this Manuals

Related products and manuals for Networking American Dynamics VideoEdge