American Dynamics VideoEdge User Manual download pdf (Page 206)

Network Settings

190 VideoEdge NVR 4.4 Installation and User Manual

2 Select Dynamic Bandwidth.

The Dynamic Bandwidth page opens.

3 Click the Pre

serve Resolution option button.

The area behind the option buttons changes to yellow indicating a change has been

made

The Traffic Smoothing fields display.

The LAN and WAN Bitrate Cap dropdowns display.

Figure 16-10 Traffic Smoothing, LAN and WAN Bitrate Caps

4 To edit the Client and Stream fields select the current values. Update the Client and

Stream values as required.

The field backgrounds change to yellow indicating a change has been made.

5 The WAN and LAN Bitrate Caps can be set to either a predefined value from the

ropdown menus or alternatively a custom value can be entered in the field.

To use a predefined value open the dropdown, select the desired predefined value from

the list.

a To use a custom value, select Custom

from the dropdown.

The custom entry field displays.

b To edit the bit

rate cap value select the current value. Update the bitrate cap value as

required.

The field backgrounds change to yellow indicating a change has been made.

Note

The custom value must be entered in kbps. For example to enter a value of

5.5Mbps you would type a value of 5500.

6 (Optional) Select the Throttle traffic to local (LAN) clients to apply bandwidth throttling

to devices sharing the same local network.

7 Click Save.

nfirmation messages display.

- End -

Allow Any Throttle Type

Any overloaded network or set caps on the NVR/client will allow the NVR to adapt the streams

accordingly by either transcoding, transcoding and framedropping on the transcoded stream and if

all the transcode resources are used, framedrop will be invoked only. If any of the above should

fail, then best effort streaming will occur.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 373 374

No comments

American Dynamics VideoEdge User Manual Page 206