American Dynamics VideoEdge User Manual download pdf (Page 34)

Installing the VideoEdge NVR

18 VideoEdge NVR 4.4 Installation and User Manual

15 Enter rw,noatime,nodiratime,attr2,nobarrier,noquota,allocsize=4m,inode64 in the

Arbitrary option

value field.

Note

nobarrier should only be used on storage devices connected to disk controllers

with battery backed cache.

16 Click OK.

17 Click

Finish.

18 Rep

eat Steps 3 to 17 to create additional media storage partitions.

19 Once th

e required number of media partitions are created click Accept.

A summary of the partitions to

be created are displayed. If you want to edit any of the

partitions click Edit Partition Setup and make the changes as required.

20 Click Next.

A summary of the partition layout

to be created is displayed.

21 Click

Install and click Install again to confirm.

The Live Installation Settings page is displayed.

22 Continue to Verify the Boot Loader location.

- End -

Verify the Boot Loader location

The boot loader must be on the same disk where the operating system software will be installed. If

the boot loader is not on the same disk the system software is located system boot problems may

occur.

Before confirming installation you can compare the location of the boot loader and the location

chos

en for system installation and partitioning.

In Figure 3-3 Live Installation Settings below the installer has chosen to use the disk /de

v/sdb for

the partitioning proposal but the disk on which to install the boot loader is /dev/sda.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 373 374

No comments

American Dynamics VideoEdge User Manual Page 34