American Dynamics VideoEdge User Manual download pdf (Page 197)

Network Settings

181

Procedure 16-10 

Viewing the DHCP Status

Step Action

1 Select Network.

2 Select DH

CP Server.

The DHCP Server settings page opens.

3 Sele

ct the DHCP Status page.

The DHCP Status page opens.

Note

You can now view all devices being managed by the NVR’s DHCP server. The

information displayed includes the IP addresses in use by the device, MAC

address for connected devices, the time a device was last active and the

Hostname for each device.

- End -

WAN Settings

The WAN Settings page allows you to configure the NVR to operate in a wide area network (WAN)

configuration. The WAN Settings page lets you specify the name or IP address that can be used to

access an NVR located behind a NAT firewall (such as a corporate LAN) that presents a single

public address for connections from outside the LAN. You can also specify the ports that are used

for HTTP, secure HTTP and streaming (RTSP) connections to the NVR. You can also enter a list

of allowed IP addresses. In addition, the General Settings page allows you to change the RTSP

Streaming Port, refer to Procedure 16-3 Editing the RTSP Port on page 174.

Note

For a new install, the Setup WAN fields display the default values. If you upgrade the NVR, these

fields will display the previously assigned values however if you carry out an appliance install the

values will be lost unless a template has been created and applied, refer to

Configuration Backup

and Templates on page 225. If you enter a value into any of these fields, that value is saved, and is

displayed until modified.

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 373 374

No comments

American Dynamics VideoEdge User Manual Page 197