American Dynamics VideoEdge User Manual Page 33

  • Download
  • Add to my manuals
  • Print
  • Page
    / 374
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 32
Installing the VideoEdge NVR
17
The Expert Partitioner page opens.
3 Se
lect the disk on which you want to create the media partition from the system view tree.
This can be either the hard disk on the NVR itself or on separate RAID or FRS storage
devices. If a hard disk on the NVR itself this would be the third physical drive in the system
tree and typically named sdc.
Note
Disks may have existing partitions. If this is the case they should be deleted
before reconfiguring a storage device by adding partitions. Deleting any storage
partitions will destroy any existing data.
4 Click Add.
5 Select
either Primary Partition or Extended Partition.
Note
A Primary Partition contains one file system. Up to four primary partitions can be
created on a single hard drive.
An Ex
tended Partition is a primary partition that has been divided up into logical
partitions as a means of creating more partitions than the four that would
otherwise be possible. Only one primary partition can be used as an extended
partition, and it can be created from any of the primary partitions. The logical
partitions do not need to fill the entire extended partition.
6 Enter the required partition size. You can select the Maximum Size option to use the
remaining disk space, or select Custom Size and enter the amount of disk space (GB) you
want to allocate to the partition.
Or
Choose an allocated region on the disk for the partition by entering a Start Cylinder and
End Cylinder
.
Note
In order to use a disk partition for storage it must meet the minimum storage
capacity requirements, 10GB.
7 Select Next
8 If
you are creating an extended partition, go to Step 18, otherwise continue to Step 10.
9 Click
the Format partition option button.
10 Select
XFS from the File System dropdown.
11 Enter the Mou
nt Point for the media partition, for example, /data/media1.
12 Sele
ct the Fstab Options... button.
13 Sele
ct the Volume Label option button.
14 Enter a Vo
lume Label in the field.
Page view 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 373 374

Comments to this Manuals

No comments