American Dynamics VideoEdge User Manual download pdf (Page 23)

Installing the VideoEdge NVR

Overview

This chapter describes the installation and configuration process for the NVR.The NVR is supplied

as either a hardware and software bundle or as a software only bundle.

NVR Hardware and Software Bundle

When the NVR is supplied as a pre-configured hardware and software bundle the basic system

settings including time and region are already applied. The system will also have default

partitioning already carried out including the required system partitions and some media partitions.

If the configured media partitions are not suitable these can be edited as required after installation,

for further information refer to Editing Storage Partitions Using

Partitioner on page 330.

The NVR is supplied with its NIC eth0 enabled, it’

s set to resolve a DHCP IP address or will be

assigned a default static IP address of 10.10.10.10 if DHCP is not available. All other NICs of the

NVR will be supplied disabled. The network settings for the NVR are configured using the Setup

Wizard.

NVR Software Only

When the NVR is supplied as software only it requires full installation onto your hardware. You

should ensure your hardware matches the minimum operation requirements, refer to System

Specifications on page 5.

Caution

Any previously configured OS on this system will be removed and overwritten.

Installing the NVR Hardware and Software Bundle

This section details the installation and configuration process for an NVR hardware and software

bundle.

The installation and configuration process consists of:

1 Initial bo

ot up of the NVR

2 Setting

up NVR OS User Accounts

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 373 374

No comments

American Dynamics VideoEdge User Manual Page 23