Appendix D: NVR Troubleshooting
335
12 On the NVR desktop double-click on the NVR Administrator icon, or on a remote
machine use Internet Explorer to log into the NVR Configuration Interface. The default
credentials are Username: admin, Password: VIDEO!edge23.
The Setup Wizard opens at the Welcome page.
13 Click
Start to begin the Setup Wizard.
The first step is to apply your licence. Apply the NVR licence file and click Con
tinue. For
further information on how to apply a license, refer to Procedure 3-15 Configuring the
Setup Page on page 29.
14 Co
ntinue through the Setup Wizard until you reach the Network section of the wizard.
Open the “VideoOSDetails-xxxxxxxx” file and use the network settings to help you
configure the following:
• Domain Name
• Domain Name Servers
• Default Gateway
• RTSP Port
• NTP Status
• NTP Servers
15 Comp
lete the remaining stages of the Setup Wizard.
When complete the NVR Configuration Interface opens at the Video List page.
16 Select
System.
17 Select
Backup/Restore.
The Backup page opens.
18 Sele
ct the Restore tab.
The Restore page opens.
19 Click
Browse.
20 Naviga
te to and select the NVR backup file, “VideoConfBackup-xxxxxxxxxxx.zip”.
You must use the zip file and not an individual sub file.
21 Click Upload Backup.
22 Y
ou will be prompted for media recovery, click Yes. Media recovery will take approximately
1 minute per 90-100GB of Storage.
Status messages will display informi
ng you of current progress.
23 Once c
omplete verify that all configuration parameters are correct.
- End -
Comments to this Manuals